Re: Zx-Uno VGA 2M (Gerbers and BOM)
Publicado: 13 May 2021, 16:22
Thanks for replies, I tested joystick 2 with MSX core.
I did have to modify my MegaDrive controller as left and right were always Gnd.
need to wire pin 7 to pin 5 inside controller (red circle)
and wire A and B buttons together for Fire 1 or you can just use only B button for Fire1) (orange circle)
C button is Fire 2
This is the pinout of the MegaDrive Controller connector:
(Select=GND)
1 Up
2 Down
3 Gnd
4 Gnd
5 5V
6 TL (Button A)
7 TH (Select)
8 GND
9 TR (Button Start)
(Select=5V)
1 Up
2 Down
3 Left
4 Right
5 5V
6 TL (Button B)
7 TH (Select)
8 GND
9 TR (Button C)
I did have to modify my MegaDrive controller as left and right were always Gnd.
need to wire pin 7 to pin 5 inside controller (red circle)
and wire A and B buttons together for Fire 1 or you can just use only B button for Fire1) (orange circle)
C button is Fire 2
This is the pinout of the MegaDrive Controller connector:
(Select=GND)
1 Up
2 Down
3 Gnd
4 Gnd
5 5V
6 TL (Button A)
7 TH (Select)
8 GND
9 TR (Button Start)
(Select=5V)
1 Up
2 Down
3 Left
4 Right
5 5V
6 TL (Button B)
7 TH (Select)
8 GND
9 TR (Button C)