ZX-Uno

Yo tambien he actualizado la flash y es una pasada tener todos los cores disponibles dentro del zxuno. Como dice ManuFerHi, con aire caliente y pasta se hace en un momento.

If I order one from here, is the correct type of chip?
http://www.ebay.com/itm/1x-W25Q128FV-W2 ... Sw9mFWImt-

bakoulis escribió:If I order one from here, is the correct type of chip?
http://www.ebay.com/itm/1x-W25Q128FV-W2 ... Sw9mFWImt-

Yes.

carmeloco escribió:

bakoulis escribió:If I order one from here, is the correct type of chip?
http://www.ebay.com/itm/1x-W25Q128FV-W2 ... Sw9mFWImt-

Yes.

Just ordered. A last question.
When de-soldered the old chip and soldered the new one, can I flash the board first time from SD, or is like a bricked board?

bakoulis escribió:Just ordered. A last question.
When de-soldered the old chip and soldered the new one, can I flash the board first time from SD, or is like a bricked board?

brick board! you need a flash chip with a preinstalled firmware or a system recovery like cable xilinx, altera, RPi, etc.

ManuFerHi escribió:

bakoulis escribió:Just ordered. A last question.
When de-soldered the old chip and soldered the new one, can I flash the board first time from SD, or is like a bricked board?

brick board! you need a flash chip with a preinstalled firmware or a system recovery like cable xilinx, altera, RPi, etc.

I write the flash before solder it, with a MiniPro TL866 programmer. Never use this programmer with the flash soldered.

I've bought something like this:
http://www.ebay.es/itm/CH341A-24-25-Ser ... Sw2GlXIKDG
The only problem is that the software does not have the option to set the QE flag (at least I could not find it).

BCH escribió:I've bought something like this:
http://www.ebay.es/itm/CH341A-24-25-Ser ... Sw2GlXIKDG
The only problem is that the software does not have the option to set the QE flag (at least I could not find it).

Some programmers, don't have the QE option. I have too a Genius G540, and don't has the QE option.