Página 1 de 1

Flashing UART core

Publicado: 27 May 2019, 22:26
por nihirash
Hello!

I've received ZX-Uno and tried to flash Core with uart support.
I've downloaded from topic abount YomboFTP EXP26 version of core. Renamed as CORE2.ZX1 and flashed it via BIOS. But it goes to endless reboot cycle.

ZX-Uno 4.2 with 512K ram.

Re: Flashing UART core

Publicado: 28 May 2019, 00:08
por antoniovillena
nihirash escribió:Hello!
But it goes to endless reboot cycle.
This endless reboot cycle is normal. You must choose the core manually. There is no way to avoid this endless cycle without replacing the main zx spectrum core.

Re: Flashing UART core

Publicado: 28 May 2019, 00:11
por nihirash
antoniovillena escribió:
nihirash escribió:Hello!
But it goes to endless reboot cycle.
This endless reboot cycle is normal. You must choose the core manually. There is no way to avoid this endless cycle without replacing the main zx spectrum core.
I've selected it from bios. I think in my experiments i've downgraded even main speccy core :?

I've cloned your repo zxuno and tried to make full flash image "flash.zx1" with replaced one core to Uart-supported. :D

I think there some goes wrong :lol: