Lost ability to boot other cores... Is this a known issue?
Publicado: 04 Jun 2018, 09:26
I am not sure at what point this occurred since Iv been almost exclusively using the Spectrum core, but I seem to have lost the ability to boot into other cores now, and I am not sure why...
I'm using a classic ZX Uno with external 2MB with firmware Alpha 73 and Spectrum core EXP v26... I just upgraded the NES core today and upon trying it out, suddenly realized that I don't have the ability to boot any core other than the Spectrum... I returned to my previous flash state and tested that, but found that this problem had been there even prior upgrading that core, so I don't know how long Iv had this problem...
Does anyone else have this issue?...
I have tried going through F2 on booting to change the start-up core, and also tried pressing DOWN cursor on booting, to select a different core from the core menu, Iv even tried the old .CORE command too, but all to no avail... Is this a known issue?... Is it related to the alpha 73 firmware perhaps?...
Basically, whenever I attempt to boot to any core other than the ZX Spectrum core, it loads the Spectrum, and defaults to the 48k rom (I usually have it set to Derby++)... I can thus no longer boot to NES/Atari/MSX/Master System/Commodore/Jupiter...
Suggestions would be appreciated, since I would really like the ability to still use the ZXUno as a multi-core system, particularly with regards to the MSX...
Thanks in advance,
Karl
I'm using a classic ZX Uno with external 2MB with firmware Alpha 73 and Spectrum core EXP v26... I just upgraded the NES core today and upon trying it out, suddenly realized that I don't have the ability to boot any core other than the Spectrum... I returned to my previous flash state and tested that, but found that this problem had been there even prior upgrading that core, so I don't know how long Iv had this problem...
Does anyone else have this issue?...
I have tried going through F2 on booting to change the start-up core, and also tried pressing DOWN cursor on booting, to select a different core from the core menu, Iv even tried the old .CORE command too, but all to no avail... Is this a known issue?... Is it related to the alpha 73 firmware perhaps?...
Basically, whenever I attempt to boot to any core other than the ZX Spectrum core, it loads the Spectrum, and defaults to the 48k rom (I usually have it set to Derby++)... I can thus no longer boot to NES/Atari/MSX/Master System/Commodore/Jupiter...
Suggestions would be appreciated, since I would really like the ability to still use the ZXUno as a multi-core system, particularly with regards to the MSX...
Thanks in advance,
Karl